TAFE NSW

Certificate III in Gas Fitting - CPC32713

TAFE NSW

Type of institution: TAFE Institute
Level: Pre-degree
CRICOS: 00591E

This qualification is part of the Construction, Plumbing and Services Training Package. It provides a trade outcome in gas fitting.

Structure

  • 32 units: 26 core
  • 6 elective

Subjects

  • Perform routine gas tungsten arc welding
  • Install LPG systems in caravans, mobile homes and mobile workplaces
  • Install LPG systems in marine craft
  • Carry out levelling
  • Erect and dismantle restricted height scaffolding
  • Handle and store plumbing materials
  • Calculate and install natural ventilation for Type A gas appliances
  • Disconnect and reconnect Type A gas appliances
  • Install gas sub-meters
  • Operate personnel and materials hoists
  • Maintain Type A gas appliances
  • Assemble mechanical services components
  • Operate elevated work platforms
  • Install Type A gas appliance flues
  • Install small bore heating systems
  • Work safely on roofs
  • Install and commission Type A gas appliances
  • Carry out interactive workplace communication
  • Carry out simple concreting and rendering
  • Provide basic emergency life support
  • Install trench support
  • Install LPG storage of aggregate storage capacity exceeding 500 litres and less than 8KL
  • Carry out WHS requirements
  • Install gas pressure control equipment
  • Read plans and calculate plumbing quantities
  • Cut and join sheet metal
  • Fabricate and install non-ferrous pressure piping
  • Carry out load slinging of off-site materials
  • Install Type B gas appliance flues
  • Cut using oxy-LPG-acetylene equipment
  • Size consumer gas piping systems
  • Install gas piping systems
  • Work safely at heights
  • Apply OHS requirements, policies and procedures in the construction industry
  • Perform routine gas metal arc welding
  • Work effectively in the plumbing and services sector
  • Weld using manual metal arc welding equipment
  • Install and test ducting systems
  • Install LPG storage of aggregate storage capacity up to 500 litres
  • Weld polyethylene and polypropylene pipes using fusion method
  • Weld using oxy-acetylene equipment
  • Mark out materials
  • Fabricate and install steel pressure piping
  • Flash penetrations through roofs and walls
  • Use plumbing hand and power tools
  • Purge consumer piping

Study pathways

This qualification is suitable for an Australian Apprenticeship pathway.

Study information

CampusFeesEntryMid year intakeAttendance
Tamworth Campus No
  • Part-time : 2 months

Fee comments

Campuses: Tamworth Campus.

**ADDITIONAL RESOURCES**You will need to provide for yourself the following resources which you will keep when you complete your study:Course related fee of $270 for materials used during practical sessions.TAFE NSW will provide the following resources:- Workbooks:- ecopy's of codes & standards (hard copies can be provides at a charge)Students must provide their own PPE. This includes , but not limited to:-- Safety clothing (cotton drill, hi-vis)- Cotton drill overalls- Safety footwear (boots)- Clear Safety glasses- Oxy goggles- Welding helmet

Further information

Completion of the general induction training program specified by the National Code of Practice for Induction Training for Construction Work (SAC 2006) is required before entering a construction work site. Achievement of unit CPCCOHS1001A covers this requirement.

Related courses

Browse more courses
Is the information on this page correct? Request update
Enquire about this course
You must agree before submitting.

Become a member

Already a member? LoginForgot password?

Join the conversation